14. how to create a basic phased array setup for weld inspection using the omniscan™ x3
Published 3 years ago • 20K plays • Length 10:15Download video MP4
Download video MP3
Similar videos
-
6:44
20. how to create a multigroup tfm setup for weld inspection on the omniscan™ x3 flaw detector
-
1:58
manual phased array (pa) weld inspection with the omniscan™ x3 flaw detector
-
3:52
9. how to create a scan plan with dla and dma probes on the omniscan™ x3
-
5:36
evident around the world: how to create a multigroup tfm setup on the omniscan™ x3 flaw detector
-
5:12
how to create a 4 tfm group setup with the omniscan™ x3 flaw detector and weldrover™ scanner.
-
8:15
olympus around the world: setting up a multigroup inspection on the omniscan™ x3 flaw detector
-
6:21
how to create a 3 point tcg with the omniscan™ x3 flaw detector
-
13:22
what’s new in mxu 5.10, the omniscan™ x3 series onboard software
-
21:01
esg-410: in-service
-
19:36
episode 1 flaw signal characteristics
-
3:33
10. how to perform sensitivity calibration for dma and dla probes on the omniscan™ x3
-
2:28
how to calibrate phased array (pa) velocity with the omniscan x3 flaw detector
-
4:40
7. wedge delay calibration on the omniscan™ x3
-
13:20
roundtable discussion of new olympus mx3 instruments
-
11:24
phased array weld inspection
-
6:20
13. sensitivity calibration on the omniscan™ x3
-
0:42
mxu 4.4 software long seam weld inspection
-
5:46
intro to weldsight™ advanced data analysis software for the omniscan™ x3 flaw detector - sneak peek
-
0:16
live phase coherence imaging (pci) on the omniscan™ x3 64 flaw detector
-
2:34
weldsight™ advanced analysis software for the omniscan™ x3 flaw detector