micron decay test through refrigerant hoses is not ! the correct way. it’s only a rough idea ? 
Published 2 years ago • 1.6K plays • Length 6:03Download video MP4
Download video MP3
Similar videos
-
2:14
vacuum pump oil. how often do i change
-
8:08
? what did i do to this ac system to stop the vacuum leak ? you tell me
-
14:28
single vacuum hose ac recharging method. micron meter explanation of use
-
1:47
recovering refrigerant down to 900 µm vacuum level not the minimum standards of just -15 vacuum.
-
3:40
not pulling deep vacuum past 29.9 inches vacuum. front shaft seal.. next video successful
-
11:51
contaminated refrigerant, a never endless supply that never worry about there being a shortage 
-
3:07
ac moisture contamination cannot pull below 700 µm valves open vacuum pump running.
-
7:56
extremely large refrigerant leak stops leaking
-
10:19
ac leaks under vacuum but not under high pressure 150 psi
-
13:29
how to replace a water pump and save $783
-
8:18
how long does it take to get to 500 µm vacuum ?
-
3:50
say no to aftermarket condensers 💊 🤣💸 listen to the angry technician. 🧑🔧
-
0:27
inducer motor tight, but not bad yet. the real problem was much simpler.
-
2:01
vacuum plateau approaching 700 µm after turning off vacuum. after 30 minutes of vacuum.
-
2:33
nylog protect your refrigerant attachment, couplings o-rings from vacuum leaks and damage
-
2:26
one 3/4” vacuum hose , no refrigerant gauges one charging hose only.
-
3:30
micron vacuum decay test on new metal lines. compared to automotive.. 
-
7:37
deep vacuum for prolonged periods of times a must for poe oil
-
2:18
extremely tiny leak at ambient temperature at static 225psi pressure with the system not running.
-
3:15
had guys tell me poor cooling problem was because of pressure did not change at high rpms 🤔
-
2:47
cheap robin air vacuum pump, cheap leaking refrigerant gauges, this is what i often find in shops.