slip & drive (aka s and drive duct) installation for hvac ductwork
Published 3 years ago • 256K plays • Length 1:47Download video MP4
Download video MP3
Similar videos
-
0:14
slip and drive duct sections are 3 inches taller than tdc duct sections
-
0:36
one piece wrap s and drive duct sections coming off of full coil line with only one longitudinal...
-
5:35
how to correctly assemble duct work?
-
1:43
spiral pipe ductwork, hvac - how it's made in the u.s.a.
-
7:01
hvac air duct making machine / duct manufacture line / auto duct line ⅲ
-
0:16
s and drive cleat
-
0:42
making 2 piece s and drive duct
-
0:19
straight duct sections slip and drive assembled and ready for jobsite
-
0:32
unassembled fiberglass lined rectangular duct fittings
-
0:28
using ductmate’s 6” tdf cleat on two sections of tdf duct
-
0:42
the most common way of joining ductwork transverse joint is s and drive
-
0:20
reverse drives in s and drive ductwork
-
0:44
making one piece slip and drive duct section on vicon full coil line
-
0:16
capping off ends with rolls of duct film before sending out large rectangular duct sections
-
0:53
turning drives on cheeks of transitions and straight duct section
-
0:56
full wrap coil line running 24 ga slip and drive duct
-
0:59
ductmate 35 flange on 5 ft straight duct sections
-
4:10
how to install a flexible duct connector on slip and drive square duct
-
0:29
2 pc straight duct slip and drive duct with snaplock down longitudinal, nested for assembly in field
-
0:13
connecting the 4 sides of the rectangular duct’s transverse joints in the duct shop means less labor
-
0:46
4 pc rectangular duct fittings with fiberglass duct liner
-
0:26
full wrap duct for hvac at the end of a coil line braking station