finishing the frame and test fitting the engine and trans in our coupe.
Published 1 year ago • 73K plays • Length 41:16Download video MP4
Download video MP3
Similar videos
-
47:44
swapping out the model t body and shortening the frame on the t hot rod
-
16:31
pontiac gets an ls, and modified x frame to fit a manual trans.
-
45:07
getting the body setup on the frame table
-
31:50
modifying the frame to fit the small block and make room for rear suspension. part 3
-
28:04
building a firewall from scratch for our 1937 ford hotrod part 7
-
51:13
redoing the rear roof section of our 1935 dodge coupe.
-
36:56
building firewall and start floor pans along with test fitting the trunk lid.
-
32:43
channeling our 37 ford pickup body and test fitting the box sides. part 2
-
38:00
attempting to get this 1930 model a sedan to run and drive again.
-
8:24
1955 international coe hauler
-
5:15
med fast road a-series camshaft kits
-
33:26
squaring the suspension and making pan hard and radiator mounts.
-
42:04
testing new parts and finishing welding the floors and painting the chassis
-
40:33
fitting the chassis to the gmc panel truck, moving the motor and the rear axle
-
31:12
building inner box frame to mount box and narrowing a tailgate to fit 37 ford pickup part 12
-
35:21
shortening s10 chassis and test fitting the 51 ford f1 body part 3
-
24:48
making a belt line for the 1928 model a special coupe and test fitting a frame under it.
-
14:17
model t hotrod - helping dan from dd speed shop turn his pile of parts into a roller
-
26:17
progress on the 51 gmc panel truck, little floor work and firewall patching.
-
37:03
making cab mounts and moving the cummins back in out ih 4x4 body swap.
-
52:41
sectioning a ford shoebox dash to a ford model t coupe.