fix bricked flight controller not flashing firmware (stm32 ) inav, betaflight, ardupilot, etc.
Published 2 years ago • 22K plays • Length 2:59Download video MP4
Download video MP3
Similar videos
-
6:54
did i brick my flight controller? recovery? dfu? bootloader? - fpv questions
-
6:48
the last resort if you can't get your flight controller into dfu mode for flashing...
-
12:07
how to "unbrick" flight controller (both ways)
-
8:15
using zadig to flash your flight controllers simply (stm32)
-
6:35
how to fix betaflight bootloader won't connect failed to open port
-
4:02
flight controller cannot go into dfu/bootloader mode | here's how!
-
5:22
fixing the inav version error 'this firmware version is not supported this version of configurator'
-
3:39
no response from bootloader, programming failed (betaflight, firmware update, impulserc fixer)
-
3:03
betaflight 4.5 motors wont spin. try this!!!
-
11:12
how to fix your gps when it isn't working (inav)
-
16:03
airbot typhoon32 4in1 esc repair
-
4:21
how to diagnose if your flight controller is dead (blue led only, can't connect with betaflight)
-
3:21
how to flash another firmware onto your flight controller (betaflight to inav, dfuse, hex to dfu)
-
4:55
how to force or fix dfu/bootloader mode on any betaflight board that won't update
-
0:04
refurbishing mambaf4 #diatone #dronefpv #stm32 #betaflight
-
5:24
drone bound but cannot arm? watch this video!
-
4:52
betaflight firmware won't update problem fix| struck in dfu mode #betaflight #problem #fix #firmware