horizontal boring mill: cutting a spline on a new blank end for the cross slide lead screw
Published 2 years ago • 41K plays • Length 24:30Download video MP4
Download video MP3
Similar videos
-
34:26
horizontal boring mill: repairing the splined end of the cross slide lead screw
-
39:01
horizontal boring mill restoration: milling an end spline to repair the crank handle
-
22:21
horizontal boring mill restoration - disassembly of the cross slide screw
-
24:44
horizontal boring mill: making a new lead screw nut with internal left hand acme threads - part 1
-
21:12
steam engine gear 3: cutting keyways and dowel pinning the bevel gear
-
33:17
horizontal boring mill restoration: reassembling the saddle and cutting oil grooves
-
32:05
1928 austin timing helical gear: turning the gear blank from a cast iron casting
-
10:10
horizontal boring mill: making a new lead screw nut with internal left hand acme threads - part 2
-
16:12
slicing a cast iron bar on the horizontal milling machine
-
28:49
making a tool bar for the horizontal mill to machine a custom spline
-
33:35
horizontal boring mill restoration: disassembling and inspecting the saddle & cross slide
-
28:13
lucas horizontal boring mill restoration: scraping the table flat
-
18:25
horizontal boring mill restoration - machining a lever detent pin
-
37:12
machining a bronze cross slide nut for a leblond lathe from a casting
-
18:34
horizontal boring mill restoration: headstock and tailstock precision alignment
-
22:31
boring on the horizontal mill - cane mill bearing
-
26:28
side milling bronze bearing castings square on the horizontal milling machine
-
28:52
horizontal boring mill restoration: scraping turcite and final alignment of the saddle
-
30:39
horizontal boring mill restoration: scraping the saddle ways flat
-
24:21
kearney & trecker low lead attachment drive shaft - cutting splines
-
39:31
machining a new bronze cross feed nut for a 1909 f. e. reed lathe