horizontal boring mill restoration: fabricating a drive dog plate for the spindle
Published 1 year ago • 49K plays • Length 25:23Download video MP4
Download video MP3
Similar videos
-
18:09
horizontal boring mill restoration: tailstock paint prep and mounting to the machine
-
29:10
machining a 45 degree angle on the metal planer
-
39:01
horizontal boring mill restoration: milling an end spline to repair the crank handle
-
33:17
horizontal boring mill restoration: reassembling the saddle and cutting oil grooves
-
39:31
machining a new bronze cross feed nut for a 1909 f. e. reed lathe
-
13:43
b-17 bomber restoration: broaching a square hole for landing gear part
-
16:34
saving a 4" thick plate with a bad torch cut hole - horizontal boring mill - manual machinist
-
18:34
horizontal boring mill restoration: headstock and tailstock precision alignment
-
32:09
lucas horizontal boring mill restoration: turning and installing a new bronze bushing
-
18:25
horizontal boring mill restoration - machining a lever detent pin
-
25:24
lucas horizontal boring mill restoration: finish scraping the bed ways co-planer
-
31:13
lucas horizontal boring mill restoration: making a morse taper no. 5 tailstock adapter
-
30:39
horizontal boring mill restoration: scraping the saddle ways flat
-
23:27
horizontal boring mill restoration: scraping, grooving and reassembling the table
-
29:48
lucas horizontal boring mill - machining a new spring loaded handle
-
22:46
monarch 612 lathe restoration: finishing up - chip tray, cross slide knobs, and way wipers
-
22:11
horizontal boring mill restoration: unboxing & inspecting the freshly ground mill table
-
27:24
horizontal boring mill restoration: installing the table lead screw and tailstock base
-
37:59
lucas horizontal boring mill restoration: machining a new tailstock crank shaft
-
28:52
horizontal boring mill restoration: scraping turcite and final alignment of the saddle