metal planer restoration 64: the belt pulley situation - responding to suggestions
Published 3 years ago • 46K plays • Length 21:06Download video MP4
Download video MP3
Similar videos
-
22:49
metal planer restoration 63: flat belts installed and... well, that did not go as planned...
-
21:11
metal planer restoration 65: moving the countershaft
-
30:40
metal planer restoration 45: machining a crowned flat belt pulley from a casting
-
21:39
metal planer restoration 46: turning a shaft and installing a pulley and gear
-
23:30
metal planer restoration 57: pulley swap and belt shifters
-
30:59
metal planer restoration 39: making a bevel gear blank on the metal lathe
-
26:09
metal planer restoration 61: machining a flat belt pulley for the mechanical oiler
-
27:03
metal planer restoration 60: installing the lubrication pump and plumbing
-
12:32
metal planer restoration 52: pressing the old shaft out of flat belt pulley hubs
-
28:09
metal planer restoration 34: machining new double t-nuts for the clapper box saddle
-
14:30
metal planer restoration 67: first movements of the table!
-
33:30
planer restoration 62: machining a flat belt lubricator pulley
-
17:44
metal planer restoration - part 29: scraping the planer table v-ways
-
32:59
removing stubborn shafts from flat belt pulleys
-
17:35
metal planer restoration 55: countershaft bearings
-
28:10
metal planer restoration 69: finally - the first chips have been cut!
-
20:49
new haven metal planer restoration - part 26: scraping the ways on the machine base
-
14:28
new haven metal planer restoration - part 21: belt shifter linkage
-
15:32
new haven metal planer restoration - part 13: installing the bull drive gear