reinforcement beads and plasma id labels are always on same side
Published 1 year ago • 164K plays • Length 0:20Download video MP4
Download video MP3
Similar videos
-
0:25
installing rectangular duct with ez corners and screw bolts
-
0:06
using labels differently on galvanneal straight duct
-
0:30
rectangular duct fittings come off plasma table then flipped over label down thru the beader
-
0:19
rectangular duct fittings are almost always 4 pcs cut out on the plasma table then assembled
-
0:20
the center hole notch legs on stacked cornermatic tdcf corners
-
0:44
assembling double wall standing seam elbows with spiral flange connectors
-
0:42
the most common way of joining ductwork transverse joint is s and drive
-
0:18
plasma table labels come either as permanent or removable
-
0:19
galvanized angle iron is used for external reinforcement bracing on ductwork
-
0:12
assembled duct with condu locks and tie rods with dyna claw cross hanger
-
0:50
plasma table to beader to buttonlock machine
-
0:58
tdc/f corners are secured by hammering or crimping the td flange over itself
-
0:42
malco s3r offset seamer turning right angle on cheeks
-
0:21
duro dyne ez corners in tdc and ductmate flanged fittings
-
0:42
vicon 12 station tdx rollformer on cheek of square elbow
-
0:34
double wall rectangular radius offset
-
0:50
vicon tdx 12 station rollformer for straight duct with female large pittsburgh on outboard side
-
0:43
cheekbenders turn the right angle on throats of square elbows
-
0:28
before plasma tables, shops had common sized fittings blanks hanging on wall to use as templates