tip #087: use board version number in the project name and in the pcb file name
Published 7 years ago • 4.5K plays • Length 4:05Download video MP4
Download video MP3
Similar videos
-
3:24
tip #051: in your schematic, always create a cover page with list of pages and page numbers
-
2:47
tip #093: put a big title on the top of each page and put a small title for each chip / connector
-
4:19
tip #072: name schematic pages by short and clear names
-
4:09
tip #031: include page number in schematic page name
-
5:06
tip #015: create a todo file to list the changes for the next board version
-
11:22
tip #100: create a board release procedure
-
5:17
tip #079: name every important net in your schematic, even if ...
-
4:29
tip #003: use “ ” sign as a prefix of all your power net names
-
1:56
how to check t-con board ,how to check panel voltage
-
8:06
tda7297 audio amplifier schematic pcb
-
4:49
in-circuit ring tester for fbt & other inductors
-
3:22
tip #010: once you name a net, always copy and paste its name. never re-write it manually.
-
5:33
tip #096: place pins in schematic symbol the easy to read and consistent way
-
4:26
tip #064: backup and possibly do versioning of your project folders
-
6:41
tip #065: if you are not sure, if put something into your schematic, add it there
-
4:30
tip #019: always be sure that the pin numbers in schematic are pointing to ...
-
5:40
tip #066: include voltage value in power net name
-
7:45
tip #058: create board variants (if your cad software supports it)
-
4:08
tip #062: on the cover page, include status of the schematic
-
5:17
tip #080: add testpoints
-
3:00
tip #077: make component outline a little bit bigger than component real size
-
2:39
tip #075: consider not using dot (“.”) in symbol description e.g. 2.2uh. do it this way instead 2u2