tip of the day! don’t have your cylinder head surfaced until it’s been straightened.
Published 2 years ago • 3.6K plays • Length 0:56Download video MP4
Download video MP3
Similar videos
-
9:26
what are the parts under the bonnet/hood of a car? ft. baleno | car driving- part 4
-
18:26
las aluminium cylinder head | welding aluminium | restoration cylinder head | cylinder head repair
-
43:32
oil and gas control room operations
-
4:53
danny soliz says – straightening cylinder heads before milling
-
0:57
tip of day! make sure your cam or cams spin freely and have a great day. make someone smile today
-
1:01
pontiac love. tip of the day . take the time and move that cylinder wall back!
-
0:16
tip of the day. always vacuum check your valve job.
-
9:47
how to prep the block surface (before installing a cylinder head) feat. danny soliz
-
30:45
how to straighten a cylinder head with a torch
-
1:01
temperature is everything to a machinist. tip of the day check everything! #hillcountryperformance
-
1:01
tip of the day. clean your bolt holes but not with a tap! #hillcountryperformance
-
28:57
can you straighten a crankshaft?! and your other machining questions answered, feat danny soliz
-
0:15
engine overhaul|| engine head reface ||head gasket replacement ||engine overheat||#shorts #reels.
-
18:04
tip of the day: never use scotch-loc’s on aluminum cylinder heads.
-
1:00
don’t make this mistake, it’s up to you the engine builder to find these issues.
-
1:58
gas trencher - because for every job that must done there is an element of fun :)
-
48:41
why i never run a cylinder head "right out of the box"!
-
0:14
heating coil making | heater coil kaise banaye | nichrome wire | nichrome heating coil |
-
0:29
helicoil spring, we can use this where the thread is weak.
-
0:16
engine runs very rough with misfire in cylinder 4, see what i found! 🤦♂️